I have two network card installed in my PC, one network card is connected to cooperation LAN, another is connected to my development system for sniffer the Ethernet data, anyone knows how to configure this card? asked 23 Oct '13, 16:07  rabbit |
2 Answers:
Normally, no special configuration is necessary to be able to capture, but it would be wise to disable all protocols on the card. So if you're running windows you should remove all protocol bindings by removing all checkmarks in the card properties. On Linux, you might configure your card as manual instead of static or dhcp. answered 24 Oct '13, 00:05  Jasper ♦♦ |
Hi: I find the right answer, setup as the second card a "transparent bridge", then all the packet goes to my PC, wireshark can capture all those data. answered 28 Oct '13, 15:47 rabbit |
