This is a static archive of our old Q&A Site. Please post any new questions and answers at ask.wireshark.org.

LLDP unicast doesnt show up in the packet capture

0

Setup: 2960S running SE6 image:
PD(Power Device) connected to port g2/0/47:
SPAN port g2/0/14

I am trying to capture the LLDP negotiations between the PD and and the cisco switch. I have the following config on the cisco switch. I have configured the SPAN to capture both side traffic (Rx and Tx) no cdp lldp run monitor session 1 source interface Gi2/0/47 monitor session 1 destination interface Gi2/0/14 encapsulation replicate

However, when I capture packets using wireshark on port Gi2/0/14 I only see the LLDP mulicasts and dont see the negotiations between the switch and the PD.

Any pointers on how to capture the unicasts or if I am missing soemthing?

Appreciate the help.

Thanks, RJ

asked 20 May '15, 12:05

rj251's gravatar image

rj251
6112
accept rate: 0%

You should over to a Cisco users forum, since this is a question on how to configure a Cisco switch for this particular situation.

(20 May '15, 22:43) Jaap ♦